User Profiles: |
Incremental_RADIOSS Incremental_LS-DYNA RADIOSS One Step Die Module |
Use the Numbers panel to display the IDs of an entity.
There are no subpanels on the Numbers panel. All inputs and command buttons are located on the main panel.
Input |
Action |
||
(entity selector) |
Use the switch to pick the desired type of entity, then use the entity selector to select the desired entities--either by picking them in the graphics area, or using the extended entity selection menu. When you select nodes or elems, click the switch to change the selection mode.
|
||
display |
After numbers have been turned on for some entities, use this checkbox to toggle the display of all numbers on and off. (This differs from the on, off, and all off buttons in that it is only temporary and does not apply specifically to the entities selected.) |
||
face angle / individual selection |
Face angleThe face angle is the angle between the normal of facets that share an element edge. A facet can either be a shell element itself, or one of the faces of a solid element. The normal of triangular facets is that of the plane defined three corner vertices. Whereas, the normal of quadrilateral facets is calculated by taking the cross-product between its two diagonals. This special treatment for quadrilaterals is because a warped shape does not lie completely on a plane. Only available when the entity selector is set to nodes or elems and the selection mode is set to faces, 2d faces ext, free edges, free edges ext, edges, or edges ext.
Individual SelectionSelect individual elements on a face or select individual free/shared edges of elements. Only available when the entity selector is set to nodes or elems and the selection mode is set to faces, free edges, or edges. |
||
edge angle |
Splits edges that belong to a given face. When the edge angle is 180 degrees, edges are the continuous boundaries of faces. For smaller values, these same boundary edges are split wherever the angle between segments exceeds the specified value. A segment is the edge of a single element. Only available when the entity selector is set to nodes and the selection mode is set to free edges, free edges ext, edges, or edges ext. |
The following action buttons appear:
Button |
Action |
on |
Turn numbering on for the selected entities. |
off |
Turn numbering off for the selected entities. In this example, 4 and 5 are selected. Clicking off clears the selection (4 and 5). |
all off |
Turn numbering off for all entities. Unlike the display checkbox, this clears the numbers--meaning that you will need to reselect and click on if you wish to re-enable numbering. |
return |
Exit the panel. |
Turn off the display of IDs of specified data types
Turn off the display of all entity IDs
An Alphabetical List of Panels