SECFEKO Command Line

The following list of options are available from the command line.

-m

Print the Feko machine codes for this machine.

-p

Print licence status summary in a table. The summary report includes a line for each floating licence indicating their respective status.

-r

Reset the floating licence servers (note that this will reset all Feko licences, reread the licence file and start the servers again).

-s

Shut down all floating licence servers. This will reset all Feko licences. The licence servers must be restarted manually.

-slocal

Shut down the floating licence server running on this machine. The licence server must be restarted manually.

-e xxx

Set licence number xxx to be the preferred licence to be checked out by you from this host. You can reset a previously selected licence by using the licence number 0, for example by using the option -e 0.

-c xxx

Manually check in licence number xxx into licence server (normally not required to be done only possibly after a power failure or similar).

-f xxx

Instead of using the default Feko licence file secfeko.dat in the default directory, use an alternative licence file xxx.

-q

Quiet mode, unattended setup with no user intervention required.

--version

Print the version information and then exit.

--delay

Special internal delay during version output.

--run-from-gui

Special execution mode for the graphical user interface (GUI).

--local-mode

For floating licences, no connection is made to the floating licence server, only the local licence file is parsed (option only applicable with -p).