AT Card
This card defines a voltage source that is applied to a voxel mesh in connection with a 時間領域差分法 (FDTD) method.
On the Source/Load tab, in the Sources on
geometry group, click the Voltage source
icon. From the ドロップダウンリスト, click the
Geometry source (AT) icon.

Figure 1. The AT - Geometry source on port dialog.
Parameters:
- Source name
- The name of the excitation to be defined.
- Name of port definition
- The name of the port.
- New source
- A new excitation is defined which replaces all previously defined excitations.
- Add to sources
- A new excitation is defined which is added to the previously defined excitations.
- Magnitude of source (V)
- Magnitude of the voltage source in V.
- Phase of source (degrees)
- Phase of the voltage source in degrees.
- Reference impedance (Ohm)
- 励振の基準インピーダンスは、Sパラメータの計算用に使用されると共に、得られた利得の計算に使用される基準インピーダンスです。この基準インピーダンスは、POSTFEKO内で反射係数を計算して表示するために使用されるデフォルトの基準インピーダンスでもあります。Sパラメータの計算でこの欄が空白または0の場合は、SPカードで指定された値が使用されます。得られた利得と反射係数の計算でこの欄が空白または0の場合は、50オームが想定されます。