SECFEKO Command Line
SECFEKO can be controlled from a command line.
The following list of options are available from the command line.
- -m
- Print the Feko machine codes for this machine.
- -p
- Print licence status summary in a table. The summary report includes a line for each floating licence indicating their respective status.
- -r
- Reset the floating licence servers (note that this will reset all Feko licences, reread the licence file and start the servers again).
- -s
- Shut down all floating licence servers. This will reset all Feko licences. The licence servers must be restarted manually.
- -slocal
- Shut down the floating licence server running on this machine. The licence server must be restarted manually.
- -e xxx
- Set licence number xxx to be the preferred licence to be checked out by you from this host. You can reset a previously selected licence by using the licence number 0, for example by using the option -e 0.
- -c xxx
- Manually check in licence number xxx into licence server (normally not required to be done only possibly after a power failure or similar).
- -f xxx
- Instead of using the default Feko licence file secfeko.dat in the default directory, use an alternative licence file xxx.
- -q
- Quiet mode, unattended setup with no user intervention required.
- --version
- Print the version information and then exit.
- --delay
- Special internal delay during version output.
- --run-from-gui
- Special execution mode for the graphical user interface (GUI).
- --local-mode
- For floating licences, no connection is made to the floating licence server, only the local licence file is parsed (option only applicable with -p).