To run the HyperWorks from HyperGraph
for the first time, follow steps 1-2. After the initial setup, you can run the
HyperWorks from the HyperGraph
toolbar as you see in Step 3.
-
From the File menu in HyperGraph, select .
The Preferences dialog appears.
-
From the Registered Preferences list, select Model Identification
Tool, and then click Load.
The HyperWorks appears on the HyperGraph menu bar.
-
From this point on, you have access to the HyperWorks from the
HyperGraph menu bar. To run the HyperWorks, select .
The
HyperWorks opens to the Select Data tab.
Note: While running the
HyperWorks, if pending job(s) from
past
HyperWorks sessions are detected, a dialog prompts you
with the following options:
- Abort: Discard pending job(s) from a previous HyperGraph session.
- Retry: Load pending job(s) from a previous HyperGraph session and restart the Fit or
Analyze operations that were suspended.
- Ignore: Ignore the pending jobs.