Supported Cards

Supported cards organized by solver.

Abaqus

ADVC

2D Element

3D Element

3D Gasket Element

Isotropic

Orthotropic

Anisotropic

Gasket

ElasticPlastic/Elastic Attributes

von Mises with Isotropic Hardening

ElasticPlastic / von Mises with Isotropic Hardening
ElasticPlastic / von Mises with Kinematic Hardening
ElasticPlastic / von Mises with Combined Hardening
Property Cards
Sets Cards
Control Cards
Friction and Contact Cards
Loadsteps and OutputBlocks

ANSYS

The input translator recognizes the ANSYS cards listed below. If an unsupported field is found in a card, a message is displayed on the status bar. The messages are also printed to the file ansys.msg. General slash commands, SOLUTION commands, POST1 commands, and POST26 commands are referred to as control cards. Unrecognized cards are written to a *.hmx file.
Note: One component collector is created for every unique combination of Type, Real, Mat, and SECNUM. Surface loads on 1D elements is not supported. Property collectors are created for each real set defined in the ANSYS deck. Material collectors are also created for each material ID encountered. The component in HyperMesh is different from the component (CM) in ANSYS.

EXODUS

Feko

LS-DYNA

Nastran

OptiStruct

PAM-CRASH 2G

Permas

Samcef

Radioss

Radioss Starter
Radioss Engine