Running the Dynamic Domain from Command Line

To run EDEM Dynamic Domain from the command line, the flag “--dyn” followed by the number 0 or 1:

 

--dyn 0 disables the dynamic domain

 

--dyn 1 enables the dynamic domain

 

This will run the Dynamic Domain with the following default values:

 

1. Check interval: 0.1
2. Number of checks: 3
3. Particle displacement: 10%

 

It is possible to specify the “check interval”, “number of checks” and “particle displacement values with the flags defined in the processing flags table.

 

Then, an example of command line with the dynamic domain would be: 

 

edem.exe --console -i simulation_deck.dem -p 4 -r 2 -w 0.1 –g 4 -t 1e-6 --dyn 1 –-dyn-interval 0.15 –-dyn-check 4 –-dyn-disp 15

 

This will use a dynamic domain with:

 

1. Check interval: 0.15s

2. Number of check: 4
3. Displacement of particle: 15% of Rmin

 

	(c) 2022 Altair Engineering Inc. All Rights Reserved. Intellectual Property Rights Notice | Technical Support