Extrude points

Extrude points

To extrude points:

Step Action
1 Activate the Extrude points command (see next block)
An Extrude points dialog box is opened.

Define the extrusion:

  • choose a transformation
  • enter the number of the successive executions of the transformation
  • click on OK
Lines are added in the Flux PEEC project.
An Extrude points dialog box is opened.

Go on extrusion:

  • go to step 2

Quit the sequence of extrusion:

  • click on Cancel

Activate the command

To activate the Extrude points command, which requires data selection choose one of the methods presented in the figure below:

Remember: To open a contextual menu, use the right button of the mouse. For multiple selections, keep the Ctrl key pressed.