# Investigate Simulation Problems

- Analysis of the Shepard coefficient (after utilizing nFX[c] or through ParaView’s SPH Volume Interpolator).
- Analysis of the information files for the FLUID phases.

## Shepherd Coefficient

The Shepard coefficient can be used to identify areas of excessive particle compression or rarefaction (Shepard coefficient in these cases is higher than 1.01 or lower than 0.99; where truly critical areas have Shepard coefficient higher than 1.1 or lower than 0.9). This holds particularly true if looking at time averaged values of the Shepard coefficient, which may indicate areas with chronic numerical issues (throughout the simulation).

## FLUID Phase Information Files

Using FLUID information files (if enabled for output) is also a good way to monitor the stability of the simulation. In order to help show how this can be done, an example case is provided and its outputs for two different setups.

The case is a 5-speed motorcycle gearbox with around 8 million particles in total and around 2 million air particles in the domain.

The first case has the reference velocity (`ref_vel`) set to 4.53
m/s and the second case has the reference velocity set to 6.18 m/s. This causes a
difference in the time step, with the time step being smaller for the second case
(higher `ref_vel`).

When analyzing the information file of the FLUID phase, find the Npart(RHO>1.1*RHO_0) and Npart(RHO>1.2*RHO_0) files. These files indicate the number of particles which exceed the nominal density of the fluid by 10 and 20% respectively. These numbers, while not an ideal or universal indicator, can help assess the simulation quality. For example, see Figure 1 where the comparison of the above mentioned cases is shown.

The results show that the case with the lower `ref_vel` (higher time
step) has higher number of particles exceeding both 10% and 20% thresholds, implying
regular violation of the CFL condition. With the steady increase of the number of
hot particles and considerable amount of particles exceeding 20% of nominal density,
the case with lower reference velocity would be deemed as flawed and the solution is
corrupted.

`ref_vel`(lower time step) shows leveling of air hot particles, keeping the total number below 1% of the total number of air particles and virtually non-existent particles that violate 20% density variation threshold. While ideally you do not want to have any hot particles at all, in this specific case it is reasonable to accept the level of the numerical error shown and assume the solution is of reasonable accuracy.

While by no means is this type of analysis an absolute or universal measure of simulation quality, it is an extremely useful tool and can be a good starting point to troubleshoot a simulation.

For more information on diagnosing a simulation which has problems, see Troubleshoot a Simulation.