# ACU-T: 2400 Supersonic Flow in a Converging-Diverging Nozzle

## Prerequisites

Prior to starting this tutorial, you should have already run through the introductory tutorial, ACU-T: 1000 Basic Flow Set Up

## Problem Description

The exit to throat area ratio of the nozzle is 1.5. The radius at the inlet is 0.892 m, while the radius at the outlet is 0.691 m. The inlet stagnation pressure and the inlet temperature are 123,567 Pa and 309.072 K, respectively. The static pressure at the outlet is set to 101,325 Pa. The fluid in this problem is air, where the flow is assumed inviscid (viscosity and conductivity are zero) and density is based on the ideal gas model.

The AcuSolve simulation will be set up to model a transient supersonic flow where the flow variables reach an asymptotic state to determine the stable flow solution.

## Start HyperWorks CFD and Open the HyperMesh Database

## Validate the Geometry

The Validate tool scans through the entire model, performs checks on the surfaces and solids, and flags any defects in the geometry, such as free edges, closed shells, intersections, duplicates, and slivers.

## Set Up Flow

### Define Material Properties

### Set Up the Simulation Parameters and Solver Settings

### Verify the Material Selection

### Define Flow Boundary Conditions

## Generate the Mesh

## Run AcuSolve

## Post-Process the Results with HW-CFD Post

In this step, you will check the contours of pressure on a mid slice plane.