Use the Section Cuts tool to cut planar or spherical
sections through a model.
Create Section Cuts
From the View Controls toolbar, click .
In the Section Cuts dialog, click to create a
new section cut.
Click of the left side of the
microdialog to select either a planar or spherical
section cut.
Change the display and position of the section cut using the other microdialog options.
Display only the section cut by clicking .
Reverse the part of the model that is hidden by clicking .
Trim elements along the plane/sphere to create a smooth section cut by
clicking .
Translate or rotate the section cut using graphical manipulators by
clicking . For
spherical section cuts, the yellow manipulator can be used to adjust the
radius of the sphere.
Tip: You can also click and drag the frame directly. After
exiting the section cut tool, these frames remain visible, allowing
you to translate or rotate a section cut at any time. For planar
section cuts, click and drag the center of the frame to translate.
Click and drag a corner or an edge to rotate.
Align the section plane to the x, y, or z-axis by clicking .
Note: Only available for planar section cuts.
Tip: To go back and adjust a section cut, right-click on it in
the Section Cuts dialog and select Edit
from the context menu.
View Section Cuts
From the View Controls toolbar, click .
In the Section Cuts dialog, enable the checkboxes of the
section cuts you wish to view.