Material Mapping Tutorial

This section will walk you through material mapping steps.

Material Mapping
Material mapping is required only for squeak lines. Hence, you will map material only for below interfaces:
  • IPsubstrate_To_ControlpanelUpper
  • Ipsubstrate_to_Dashboardpanel

E-Line Visibility options

  1. You will see all of the realized ELines in the panel table.


    Figure 1.
  2. Turn on the visibility for the squeak lines using the Visibility column checkboxes.


    Figure 2.
  3. Check the boxes of the isolated E-Lines under the Select column.
    This selects only the lines required for material mapping.
  4. Select ABS from the Map Material 1 drop-down list.
  5. Select PPTD_20 from the Map Material 2 drop-down list and click Map Material .
    This maps the selected materials to the interface.


    Figure 3.
  6. Click Next to continue to the Loadcase Setup section, which is the next step in the process.