Material Mapping Tutorial

This section will walk you through material mapping steps.

Material Mapping
Material mapping is required only for squeak lines. Hence, you will map material only for below interfaces:
  • IPsubstrate_To_ControlpanelUpper
  • Ipsubstrate_to_Dashboardpanel

E-Line Visibility options

  1. You will see all the realized ELines in the panel table.


    Figure 1.
  2. Turn on the visibility for the squeak lines using the Visibility column check boxes.


    Figure 2.
  3. Check the boxes of the isolated E-Lines under Select column.
    This selects only the lines required for material mapping.
  4. Select ABS from Map Material 1 drop down list
  5. Select PPTD_20 from Map Material 2 drop down list and click Map Material .
    This will map the selected materials to the interface.


    Figure 3.
  6. Click Next to continue to Loadcase Setup section, which is the next step in process.