EPH - PHASES

Number of phases bigger than maximum allowed (#1).

The maximum number of phases is limited to 100. Please note that each subphase group (WALL and MOVINGWALL) counts as one phase.

The simulation cannot start without a valid "phases" section.

The cfg file must contain a "phases" section. Please define one and assign appropriate values. Please ensure that there are no typographical mistakes and the cfg file has Linux line endings.

The contact angle requested for phase #1 has an invalid value: #2.";

Contact angle needs to be a value between 0 and 180 degrees.

Phase #1, requested for calculating fluid contact time of solid phase #2, is larger than the total number of phases, #3.

The requested fluid contact phase number "fluidContactPhase" exceeds the number of phases defined in the "phases" section.

The fluid contact time is requested for phase #1 which is not a WALL or MOVINGWALL.

Fluid contact time is only available for WALL or MOVINGWALL phases. In other words, "fluidContactPhase" keyword is restricted to WALL and MOVINGWALL phase types.

The non-fluid phase #1 is assigned for calculating fluid contact time of solid phase #2.

The solver measures the contact time of FLUID phases with WALL or MOVINGWALL phases only. In other words, the value of "fluidContactPhase" keyword must point to a FLUID phase.

Subphase option is not supported with energy transport in non-isothermal solids.

Sub phasing feature is not available when energy transport is active and wall or movingwall phases have evolving temperature fields. Please either set "evolve_temp" to false or set "makesubphase" to false.