*lineextendtonode

Extends the specified line to a node.

Syntax

*lineextendtonode line node capture_radius derivative direction

HyperMesh Tcl Modify Command

Extends the specified line to a node.

line: The ID of the line to extend.
node: The ID of the node to which the line is extended.
capture_radius: If the point at the end of the extension is within the capture_radius of the node, then force the end point to have the same coordinates as the node.
derivative: 1 - Extend the tangent to the line; 2 - Extend following the curvature of the line
direction: 1 - Extend the end of the line; -1 - Extend the beginning of the line

None.