Dynamic Load Creation

In this step you can combine transient loads to create a Dynamic load. The panel for this operation is shown below.

Figure 1.

The operations that can be performed on this panel are:

1. Select Subcase - select the required subcase from a drop-down list.
2. Scale Factor - provide a scaling factor for the dynamic load
3. Constraints list table -
   1. All of the transient loads created in the previous tasks are listed in the first table.
   2. Allows you to select constraint(s) to combine.
   3. You can use the selection options in the table.
      1. Select All
      2. Unselect All
      3. Reverse Selection
4. Add - create and add the DLOAD cards in the second table.
5. Refresh - refresh the table data.
6. Update - update a previously created DLOAD card
7. Delete Selected and Delete All options to delete the DLOAD cards from the second table.