Transient Load Creation Tutorial
Create TLoads
-
Click the required table from the TABLED1 drop-down list.
The drop-down list shows all of the loads created in the Load Creation Tutorial step.
Figure 1. -
Click the required unit load from the DAREA/SPCD drop-down list.
The drop-down list shows all of the tables created in the Constraint Creation Tutorial step.
Figure 2. -
Click Add.
The adjacent table shows the newly created transient load collector.
Figure 3. -
Repeat the above steps to create transient loads for the below selection.
- MTRAN_TABLED1_2 and MTRAN_SPCD_EnforcedDisp_528173_Y
- MTRAN_TABLED1_3 and MTRAN_SPCD_EnforcedDisp_528173_Z
-
Check the boxes under the Select column and click Next to proceed to the next step in
the process.
Note: You should create at least one load collector in this panel before moving to the next step.