*lineextendtosurf

Extends the specified line to a surface.

Syntax

*lineextendtosurf line surface capture_radius derivative direction

HyperMesh Tcl Modify Command

Extends the specified line to a surface.

line: The ID of the line to extend.
surface: The ID of the surface to which the line is extended.
capture_radius: If the point at the end of the extension is within the capture_radius of the surface, then force the end point to be on the surface.
derivative: 1 - Extend the tangent to the line; 2 - Extend following the curvature of the line
direction: 1 - Extend the end of the line; -1 - Extend the beginning of the line

None.