*midsurface_edit_base_surfaces

Adds or removes surfaces to the base surfaces used in midsurfacing.

Syntax

*midsurface_edit_base_surfaces mark_id mode distance skip_drawing_duplicates

HyperMesh Tcl Modify Command

Adds or removes surfaces to the base surfaces used in midsurfacing.

mark_id: The ID of the mark containing the surfaces to add or remove. Valid values are 1 and 2.
mode: The mode for the selected surfaces. Valid values are:; 1 - Add to base surfaces; -1 - Remove from base surfaces
distance: The distance from the base surfaces to the mid-surface.
skip_drawing_duplicates: 0 - Draw duplicate unfaceted surfaces (with surface lines) inside the "^Base surfaces" component.; 1 - Skip drawing duplicate unfaceted surfaces (with surface lines) inside the "^Base surfaces" component.

To add surfaces 10 and 20 with a distance of 1.5 to the base surfaces:

*createmark surfs 1 10 20
*midsurface_edit_base_surfaces 1 1 1.5 0

None.

11.0

2019 - Argument four was previously reserved but is now implemented as skip_drawing_duplicates.