*surfacecopyedges

Create lines from the edges of a surface.

Syntax

*surfacecopyedges surface list all_edges

HyperMesh Tcl Modify Command

Create lines from the edges of a surface.

surface: A surface that contains edges (a full sphere or torus does not contain edges).
list: The mark ID of the nodes used to select the surface edges (if all_edges is 0).
all_edges: 1 - Copy all edges of the surface to new lines.; 0 - Only copy edges that have a node created on them (from list).

To copy all edges of surface 1 to new lines:

*createlist nodes 2 
*surfacecopyedges 1 2 1

*createmark() is required for this command.

None.