*midsurface_offset_by_targets_11

Offsets a surface according to the targets that are attached to its vertices and edges.

Syntax

*midsurface_offset_by_targets_11 surface mode

HyperMesh Tcl Modify Command

Offsets a surface according to the targets that are attached to its vertices and edges.

surface: The ID of the surface to offset.
mode: The mode for the selected surfaces. Valid values are:; 1 - Preserves the planarity of the surfaces that were planar before the offset; Any other value - A planar surface might become curved if the targets set to offset the surface are not in one plane.

To offset the mid-surface from a surface with ID 109:

*midsurface_offset_by_targets_11 109 1

None.

11.0