Use the Apply Result panel to apply the result's analysis data to selected entities
of your model, or create loads from the analysis data.
Location: Post page
To use the Apply Results panel you must load an analysis results file containing
analysis data. Figure 1. Result Data Applied to Model Entities
Displacements Subpanel
Option
Action
simulation=
Select a simulation type.
data type=
Select a data type.
total disp
By default, the total displacement (total disp) value of the
node is used to offset the model.
entity selector
Select entities to which the result data should be
applied.
mult=
To multiply the values in the results file by a scale
factor other than 1.0, enter a new scale factor.
Create Loads Subpanel
Option
Action
simulation=
Select a simulation type.
data type=
Select a data type.
load type
Select a load type to create.
The load type(s) available
depend on the data type in the results file. If you have
vector results, you can create flux or temperature loads. If
you have scalar results, you can create forces,
accelerations, moments, or velocities.
magnitude%
Define the magnitude to display loads.
By default, loads
are displayed using a representation of 100% of their
magnitude.
relative size/uniform size
By default, loads are displayed relative to the model
size.
relative size=
Display loads in a size relative to the model size (default 100).
uniform size=
Display all loads with the same size.
mult=
To multiply the values in the results file by a scale
factor other than 1.0, enter a new scale factor.
label loads
Display the load's text labels in modeling window.
